4 Channel Analog Output Card
- Analog line outputs.
- 4 channels per card.
- High output levels for long cable runs. Up to +24 dBu.
- Digital trim. +12dB down to full off.
- Extended dynamic range D/A converters. >117 dB.
- Easy wiring. 3.81mm terminal blocks, 12 position plugs with strain relief pull tabs.
- Field swappable by qualified technicians.
General Specifications
|
Number of Outputs |
Four (4) balanced line level. |
|
Connectors |
3.81 mm terminal blocks. |
|
Nominal Output Level |
+4 dBu with 20 dB of headroom. |
|
Maximum Output Level |
+24 dBu (+22.8 dBu into a 2k Ohm minimum load). |
|
Output Impedance |
300 Ohms balanced, 150 Ohms unbalanced. |
|
Dynamic Range |
> 117 dB, A-weighted. |
|
THD + Noise |
< -95 dB, unweighted; 1 kHz @ +22 dBu with 0 dB gain. |
|
Latency |
0.60 mS |
Mechanical Data
|
Shipping Weight |
1 lbs. (0.45 kg) |
|
Certifications or Compliance |
EN 55103-1, EN 55103-2, FCC Part 15, RoHS. |
Architect and Engineer Specifications: SymNet 4 Channel Analog Output Card.
The device shall provide four analog line outputs to an EDGE or RADIUS AEC frame that are adjustable with fine trim. Up to four of these devices may be installed in a single EDGE frame
for up to sixteen channels of local output and up to one of these devices may be installed in a single RADIUS AEC frame for up to four channels of local output. Levels and mutes shall be
controllable via software. Audio outputs shall be accessed via rear panel 3.81 mm terminal block connectors.
Audio conversion shall be 24-bit, 48 kHz. The dynamic range shall not be lower than 117 dB, A-weighted with a maximum output level of +24 dBu.
The device shall comply with CE and FCC Part 15 emissions limits. The device shall be RoHS compliant. The mounting plate shall be constructed of cold rolled steel, and mount into a SymNet Radius AEC or EDGE frame I/O card slot. The device shall be a Symetrix SymNet 4 Channel Analog Output Card.
